MgB2 Superconductor

From Advanced Projects Lab
Revision as of 14:19, 11 May 2018 by Bsboggs (talk | contribs) (Processing Post-Reacted Samples)
Jump to: navigation, search

MgB2 Superconductor Project

Preparing Samples

1) Weigh appropriate amounts of Mg and B powders.
2) Mix and grind powders (in mortar) for ~ 15 minutes.
3) Pack and press the resulting powder into sheathing material.
4) Mechanically deform sample (crush the core) into a slug, ribbon or wire.
5) Heat (possibly two or more temps for two or more times)in stainless steel (SS) boat.

Processing Post-Reacted Samples

1) Possibly mechanically deform again.
2) Possibly sinter again.
2) Cut off sample ends (exposing clean sample cores).
3) Polish sample ends.

The processed samples should have reasonably low (room temp) resistivities (on the order of 0.001 Ohm x cm). The resistance R = (resistivity x length)/area.