Difference between revisions of "Populating the PCB"
Aplstudent (talk | contribs) (Created page with "Before components can be soldered into the board, the necessary holes need to be drilled. The PCB program should have included where these holes need to be, or if you made a c...") |
Aplstudent (talk | contribs) |
||
| Line 1: | Line 1: | ||
| − | + | Once the new clean board has had the acetone washed off, any through-holes need to be drilled. | |
| + | |||
| + | Use the drill press at maximum speed with the miniature carbide drill bits. WEAR GOGGLES, these bits are notable for shattering. Push the bits through the board slowly - they are going at 1/30 of their intended speed in our press! Typical drill holes are .028 for wire pins, .035 and .042 for normal device pins. | ||
| + | |||
| + | The board obviously will not have plated through holes the way professionally manufactured boards do. Any connections must be soldered on both sides of a through-hole device, and any vias must have wires run through and soldered. | ||
Revision as of 13:42, 6 February 2019
Once the new clean board has had the acetone washed off, any through-holes need to be drilled.
Use the drill press at maximum speed with the miniature carbide drill bits. WEAR GOGGLES, these bits are notable for shattering. Push the bits through the board slowly - they are going at 1/30 of their intended speed in our press! Typical drill holes are .028 for wire pins, .035 and .042 for normal device pins.
The board obviously will not have plated through holes the way professionally manufactured boards do. Any connections must be soldered on both sides of a through-hole device, and any vias must have wires run through and soldered.
